1100 – 2400 Ampere OFF-Load Switches

L800 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

The L-Series

The switches of the L-series from 350 A to 2400 A are continuous current rated for off-load switching. They are designed for switching of resistive or low-inductive loads. The terminals are able to connect either cable lugs or copper bus bars. This series have easily accessible terminals – even when the switch is already mounted.

The terminals are accessible either horizontally or vertically. Auxiliary contacts, padlock devices and door clutches are only a few possible optional extras, which are applicable to this switch series.

Catalog 100: C-, CA-, CAD-, L-Switches: 10 A – 2400 A

L1000 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

L1000

Thermal Current:
lu/lth [A]: 1000

Utilization Category (3 x 380 V – 440 V):
AC-21B [A]: 400
AC-23B [kW]: 90

Datasheet

L800 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

L800

Thermal Current:
lu/lth [A]: 1100

Utilization Category (3 x 380 V – 440 V):
AC-21B [A]: 630
AC-23B [kW]: 132

Datasheet

L1200 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

L1200

Thermal Current:
lu/lth [A]: 1450

Utilization Category (3 x 380 V – 440 V):
AC-21B [A]: 800
AC-23B [kW]: 132

Datasheet

L1600 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

L1600

Thermal Current:
lu/lth [A]: 1900

Utilization Category (3 x 380 V – 440 V):
AC-21B [A]: 800
AC-23B [kW]: 132

Datasheet

L2000 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

L2000

Thermal Current:
lu/lth [A]: 2400

Utilization Category (3 x 380 V – 440 V):
AC-21B [A]: 800
AC-23B [kW]: 132

Datasheet

According to IEC 60947-3, EN 60947-3, VDE 0660 part 107.

  • ON/OFF-Switches
  • Changeover switches
  • Step switches

Basically, the L-series are designed for vertical wiring. Horizontal wiring is available for Panel Mounting and Base Mounting.

Panel Mounting

The Panel Mountings are wel-used mountings which cover wide application ranges.

  • The four hole mountings, which are fixed by 4 screws around the center shaft hole. The four hole mountings provide several variations which make them fit for all tasks.

Base Mounting

Base Mounting is used to fix a switch at the rear side, therefore it is the commonly used mounting for larger distribution cabinets.
The switch can be mounted at the base panel by four screws. For this mounting, several door clutches with or without padlock are available.