350 – 800 Ampere OFF-Load Switches

L350 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

The L-Series

The switches of the L-series from 350 A to 2400 A are continuous current rated for off-load switching. They are designed for switching of resistive or low-inductive loads. The terminals are applicable to connect either cable lugs or copper bus bars. This series has easily accessible terminals – even when the switch is already mounted.

The terminals are accessible either horizontally or vertically. Auxiliary contacts, padlock devices and door clutches are only a few possible optional extras, which are applicable to this switch series.

Catalog 100: C-, CA-, CAD-, L-Switches: 10 A – 2400 A

L350 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

L350 / L351

Thermal Current:
lu/lth [A]: 350

Utilization Category (3 x 380 V – 440 V):
AC-21B [A]: 250
AC-23B [kW]: 90

Datasheet (L350)
Datasheet (L351)

L400 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

L400

Thermal Current:
lu/lth [A]: 500

Utilization Category (3 x 380 V – 440 V):
AC-21B [A]: 450
AC-23B [kW]: 132

Datasheet

L630 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

L630 / L631

Thermal Current:
lu/lth [A]: 630

Utilization Category (3 x 380 V – 440 V):
AC-21B [A]: 350
AC-23B [kW]: 90

Datasheet (L630)
Datasheet (L631)

L600 (with cable lug/copper bus, L-series, cam switch, Kraus and Naimer, K&N)

L600

Thermal Current:
lu/lth [A]: 800

Utilization Category (3 x 380 V – 440 V):
AC-21B [A]: 500
AC-23B [kW]: 132

Datasheet

According to IEC 60947-3, EN 60947-3, VDE 0660 part 107.

  • ON/OFF-Switches
  • Changeover switches
  • Step switches

Basically, the L-series are designed for vertical wiring. Horizontal wiring is available for Panel Mounting and Base Mounting.

Panel Mounting

The Panel Mountings are well-used mountings which cover wide application ranges.

  • The four hole mountings, which are fixed by 4 screws around the center shaft hole. The four hole mountings provide several variations which make them fit for all tasks.

Base Mounting

Base Mounting is used to fix a switch at the rear side, therefore it is the commonly used mounting for larger distribution cabinets. 
The switch can be mounted at the base panel by two or four screws and also by 'Snap-On' for DIN rail mounting.. For this mounting, several door clutches with or without padlock are available.