115 – 315 Ampere Screw Terminal
The C-Series
The C-series switches represent the classic cam switch by Kraus & Naimer and is available with screw & ring type terminals. This series has easily accessible captive terminal screws – even with the switch already mounted.
The finger-proof terminals are accessible either horizontally or vertically. The switches of the C-series offer a solution for most cam switch applications. Different contact designs, contact materials and terminals allow for their use as control switches, instrumentation switches and motor switches as well as in electronic circuitry and aggressive environments.
Catalog 100: C-, CA-, CAD-, L-Switches: 10 A – 2400 A
C80
Thermal Current:
lu/lth [A]: 115
Utilization Category (3 x 380 V – 440 V):
AC-23A [kW]: 45
AC-3 [kW]: 30
Datasheet
C125
Thermal Current:
lu/lth [A]: 150
Utilization Category (3 x 380 V – 440 V):
AC-23A [kW]: 75
AC-3 [kW]: 37
Datasheet
According to IEC 60947-3, EN 60947-3, VDE 0660 part 107.
- ON/OFF-Switches
- Changeover switches
- Step switches
- General application switches
- Series general application switches
- Series-parallel general application switches
- Motor switches
Basically the C-series are designed for vertical wiring. Horizontal wiring is available for Panel Mounting and Base Mounting.
Panel Mounting
The Panel Mountings are well used mountings which cover wide application ranges. They consist of two main groups.
- The two/four hole mountings, which are fixed by (2/4) screws around the center shaft hole.
- While with the single-hole mountings the shaft hole is used for fixation.
The two/four hole mountings provide several variations which make them fit for all tasks.
Base Mounting
Base Mounting is used to fix a switch at the rear side, therefore it is the commonly used mounting for larger distribution cabinets.
The switch can be mounted at the base panel by two or four screws and also by 'Snap-On' for DIN rail mounting. For this mounting, several door clutches with or without padlock are available.